This fixes clipping if the encoder input used the full 16 bit
input range (samples with a magnitude below 16383 worked fine).
The filtered subband samples should be 15 bit maximum, while
the code earlier produced them scaled to 16 bit.
This makes the decoder output have double the magnitude
compared to before.
The spec reference samples doesn't test the QMF at all, which
was why this part slipped past initially.
(cherry picked from commit b087ce2bee)
Signed-off-by: Martin Storsjö <martin@martin.st>
We need to do unsigned saturation in order to cover the corner case when the
absolute coefficient value is 16777215 (the maximum value).
Fixes Bug #216
(cherry picked from commit d483bb58c3)
Signed-off-by: Reinhard Tartler <siretart@tauware.de>
This prevents us from reading before the start of the buffer, and thus
prevents crashes resulting from this behaviour. Fixes bug 237.
(cherry picked from commit 291c9b6285)
Signed-off-by: Reinhard Tartler <siretart@tauware.de>
We need to set ms_stereo in encode_init() in order to avoid incorrectly
encoding the first frame as non-m/s while flagging it as m/s. Fixes an
uncomfortable pop in the left channel at the start of playback.
CC:libav-stable@libav.org
(cherry picked from commit 51ddf35c90)
Signed-off-by: Reinhard Tartler <siretart@tauware.de>
ff_wma_init() allows up to 50kHz, but this generates an exponent band
size table that requires 65 bands. The code assumes 25 bands in many
places, and using sample rates higher than 48kHz will lead to buffer
overwrites.
CC:libav-stable@libav.org
(cherry picked from commit 1ec075cfec)
Signed-off-by: Reinhard Tartler <siretart@tauware.de>
This is near the theoretical limit for wma frame size and is the most that
our decoder can handle. Allowing higher bit rates will just end up padding
each frame with empty bytes.
Fixes invalid writes for avconv when using very high bit rates.
CC:libav-stable@libav.org
(cherry picked from commit c2b8dea182)
Signed-off-by: Reinhard Tartler <siretart@tauware.de>
The maximum theoretical frame size is around 17000 bytes. Although in
practice it will generally be much smaller, we require a larger buffer
just to be safe.
CC: libav-stable@libav.org
(cherry picked from commit dfc4fdedf8)
Signed-off-by: Reinhard Tartler <siretart@tauware.de>
This allows it to be used with get_bits without the thread of overreads.
Found-by: Mateusz "j00ru" Jurczyk and Gynvael Coldwind
CC: libav-stable@libav.org
(cherry picked from commit 1aa708988a)
Signed-off-by: Reinhard Tartler <siretart@tauware.de>
Prevents warnings because the dst and src overlap (are the same) in the
memcpy() inside the function.
Found-by: Mateusz "j00ru" Jurczyk and Gynvael Coldwind
CC: libav-stable@libav.org
(cherry picked from commit 9d87374ec0)
Signed-off-by: Reinhard Tartler <siretart@tauware.de>
Prevents using the invalid mode as an index in a static array, which
would generate invalid reads.
Found-by: Mateusz "j00ru" Jurczyk and Gynvael Coldwind
CC: libav-stable@libav.org
(cherry picked from commit 154b8bb800)
Signed-off-by: Reinhard Tartler <siretart@tauware.de>
Useful to return instead of -1 when the cause of the error is unknown,
typically from an external library.
(cherry picked from commit c9bca80132)
Conflicts:
doc/APIchanges
libavutil/avutil.h
Signed-off-by: Reinhard Tartler <siretart@tauware.de>
Fixes invalid reads while initializing the dequant tables, which uses
the bit depth to determine the QP table size.
Found-by: Mateusz "j00ru" Jurczyk and Gynvael Coldwind
CC: libav-stable@libav.org
(cherry picked from commit 0ce4fe482c)
Signed-off-by: Reinhard Tartler <siretart@tauware.de>
Seeking back on EOF will reset the EOF flag, causing us to re-enter
the loop to find the next marker in the ASF file, thus potentially
causing an infinite loop.
Found-by: Mateusz "j00ru" Jurczyk and Gynvael Coldwind
CC: libav-stable@libav.org
(cherry picked from commit bb6d5411e1)
Signed-off-by: Reinhard Tartler <siretart@tauware.de>
They cause various issues further down in demuxing.
Found-by: Mateusz "j00ru" Jurczyk and Gynvael Coldwind
CC: libav-stable@libav.org
(cherry picked from commit 6e57a02b9f)
Signed-off-by: Reinhard Tartler <siretart@tauware.de>
The functions are already av_ prefixed and intfloat header is already provided.
Install libavutil/intfloat.h
Signed-off-by: Paul B Mahol <onemda@gmail.com>
Signed-off-by: Anton Khirnov <anton@khirnov.net>
(cherry picked from commit 8b933129b9)
Conflicts:
doc/APIchanges
Signed-off-by: Anton Khirnov <anton@khirnov.net>
Based in part by a fix from Michael Niedermayer <michaelni@gmx.at>
Fixes CVE-2011-3947
Found-by: Mateusz "j00ru" Jurczyk and Gynvael Coldwind
(cherry picked from commit b57d262412)
Signed-off-by: Reinhard Tartler <siretart@tauware.de>
Splits at borders of cells are invalid, since it leaves one of the
cells with a width/height of zero. Also, propagate errors on buffer
allocation failures, so we don't continue decoding (which crashes).
Found-by: Mateusz "j00ru" Jurczyk and Gynvael Coldwind
CC: libav-stable@libav.org
(cherry picked from commit fc9bc08dca)
Signed-off-by: Reinhard Tartler <siretart@tauware.de>
Because in contrast to the decoder, the parser does not setup low_delay.
The code in parse_nal_units would always end up setting has_b_frames
to "1", except when stream is explicitly marked as low delay.
Since the parser itself would create 'extradata', simply reopening
the parser would cause this.
This happens for instance in estimate_timings_from_pts(), which causes the
parser to be reopened on the same stream.
This fixes Libav #22 and FFmpeg (trac) #360
CC: libav-stable@libav.org
Based on a patch by Reimar Döffinger <Reimar.Doeffinger@gmx.de>
(commit 31ac0ac29b)
Comments and description adapted by Reinhard Tartler.
Signed-off-by: Reinhard Tartler <siretart@tauware.de>
(cherry picked from commit 790a367d9e)
Signed-off-by: Reinhard Tartler <siretart@tauware.de>
Specifically, prevent jumping back in the file for the next index, since
this can lead to infinite loops where we jump between indexes referring
to each other, and don't read indexes that don't fit in the file.
Found-by: Mateusz "j00ru" Jurczyk and Gynvael Coldwind
CC: libav-stable@libav.org
(cherry picked from commit aac07a7a4c)
Signed-off-by: Reinhard Tartler <siretart@tauware.de>
Prevents crash when trying to copy from a non-existing plane in e.g.
a RGB32 reference image to a YUV420P target image
Found-by: Mateusz "j00ru" Jurczyk and Gynvael Coldwind
CC: libav-stable@libav.org
(cherry picked from commit 830f70442a)
Signed-off-by: Anton Khirnov <anton@khirnov.net>
Also fixes crashes on corrupt bitstreams.
Found-by: Mateusz "j00ru" Jurczyk and Gynvael Coldwind
CC: libav-stable@libav.org
(cherry picked from commit 33cd32b389)
Signed-off-by: Anton Khirnov <anton@khirnov.net>
This prevents crashes when trying to read beyond the end of the buffer
while decoding frame data.
Found-by: Mateusz "j00ru" Jurczyk and Gynvael Coldwind
CC: libav-stable@libav.org
(cherry picked from commit be129271ea)
Signed-off-by: Anton Khirnov <anton@khirnov.net>
Prevents crashers when using the packet if allocation failed.
Found-by: Mateusz "j00ru" Jurczyk and Gynvael Coldwind
CC: libav-stable@libav.org
(cherry picked from commit 31632e73f4)
Signed-off-by: Anton Khirnov <anton@khirnov.net>
This prevents crashers and errors further down when reading nodes in the
empty tree.
Found-by: Mateusz "j00ru" Jurczyk and Gynvael Coldwind
CC: libav-stable@libav.org
(cherry picked from commit 2b83e8b700)
Signed-off-by: Anton Khirnov <anton@khirnov.net>
We read sub_packet_h / 2 packets per line of data (during deinterleaving),
which equals zero if sub_packet_h <= 1, thus causing us to not read any
data, leading to an infinite loop.
Found-by: Mateusz "j00ru" Jurczyk and Gynvael Coldwind
CC: libav-stable@libav.org
(cherry picked from commit e30b3e59a4)
Signed-off-by: Anton Khirnov <anton@khirnov.net>
The AVOptions based default to threads auto in 2473a45c8
works only if avplay does not use custom option handling
for -threads.
CC: <libav-stable@libav.org>
(cherry picked from commit e48a70e6da)
Signed-off-by: Anton Khirnov <anton@khirnov.net>
The parser uses VLC tables initialized in vc1_common_init(), therefore
we should call this function on parser init also.
Found-by: Mateusz "j00ru" Jurczyk and Gynvael Coldwind
CC: libav-stable@libav.org
(cherry picked from commit c742ab4e81)
Conflicts:
libavcodec/vc1.h
Signed-off-by: Anton Khirnov <anton@khirnov.net>
Martin Storsjö